Selection of installation location of fan water curtain

1.In general, fan water curtains should be installed on the exterior walls of buildings to minimize convection distances.

2.Fan water CurtainIt can be installed on walls and windowsill, but the installation environment should guarantee air circulation and freshness. Toilets, kitchens, chemical vents, such as smelly or odorous gas vents should not be set up water curtain, such as windows or doors not enough to ventilate, should be in the negative pressure ventilation place to set wall holes to ensure the air demand in the workshop.

3.The fan is mounted on a distance from the ground1M to1.5The position of the rice, so that the convection at the appropriate height, to create a fresh environment.

4.Fan water Curtain ventilation system is installed in two ways: vertical and horizontal.

5.To ensure that the fan water curtain system installation position frame structure is stable, strength can withstand the weight of the entire equipment and maintenance personnel.

　　Technical requirements for installation of fan water curtain

1.Before installation, the bracket is welded with angle steel. Its reference dimensions are determined by the dimensions required for on-site installation. With six PCsM10Expansion bolts and two PCsM10Wear wall bolts to secure the bracket where it is to be installed.

2.In order to maintain the safety of personnel and machines during maintenance and the stability of the fan itself, it should be used40*40*4Or50*50*4Of Angle steel.

3.The installation should be done by our technicians alone. To the installation diagram as the standard, according to the actual situation of the installation site to optimize.

4.The specific installation steps for fan water curtain are as follows:

　　Remove the window that will be fitted with a fan or water curtain, and clean the frame inside the window.

　　Then install the fan or water curtain according to the drawing. Before installation, the bracket should be welded with angle steel. Fans and water curtains should be installed horizontally. The fixing screws shall be sturdy and stable. After water curtain installation, the edge of the application of glass glue seal, so as not to affect the convection effect.

　　Secondly, a negative pressure fan is installed on the windowsill of the longitudinal convection of the water curtain. Note: After the fan is installed, seal the edges with a sealant plate so as not to affect the convection effect. After the fan is fixed, a protective net shall be installed at the outlet of the fan to avoid the danger caused by the close contact between the personnel and the wind wheel.

　　The third step is to arrange water pipes and water tank pumps according to construction drawings and actual conditions.